Publicidad
Design Features
Gain Control
The input gain control is preset to match
the output of most source units.
Variable Crossover
Is a built-in 12dB/octave Butterworth filter with
a crossover point variable from 50Hz to 200Hz.
Power/Protect LED
Power LED illuminates green
when the unit is turned on.
Protect LED illuminates red
if a short circuit or to low of
an impedance is detected at
the speaker connections.
The amplifier will automati-
cally shut down if this oc-
curs.
Punch Bass
This is an adjustable Bass control adjustment vari-
able from 0dB to +12dB @ 45Hz.
4
Phase Switch
Allows you to select the output phase of
the amplifier between 0° and 180°.
GAIN
MIN
X-OVER
50Hz
BASS
BOOST
0dB
Power Connector
The power connector allows for quick connec-
tion and disconnection of the amplifier's Re-
mote, power and ground source. The power and
ground are set-screw wire connectors and will
accommodate 4 AWG. The remote is a set-screw
wire connector and will accommodate 8 AWG.
Input Level
Set the Input Level switch to match the outputs of your source unit.
(LO - RCA or HI - Speaker Level)
Auto Turn On
Three different automatic turn-on modes can be selected;
REM(+12V), DC Offset, and Audio.
INPUT
AUTO
PHASE
LEVEL
TURN ON
0˚
LO
REM
DC OFFSET
180˚
HI
AUDIO
MAX
REMOTE
AUDIO INPUT
200Hz
FUSE
PWR
FUSE
PRO
12dB
Audio Input
The RCA/Speaker Harness utilizes either speaker
level (high-level) or RCA (low-level) inputs.
Remote Punch Level
When connected, the "Gain Control" is linked
and allows you to remotely control the output
level of the amplifier from the dash or center
console.
illus.-2.1
Publicidad
