Drive 14001E Manual De Usuario página 4

Installation
Step 1 Place the bubble pad flat on a base mattress, which should be on a bed frame.
The inflation tubes should be towards the foot end so that they can be connected to
the inflation nozzles on the pump.
Step 2 Cover with a cotton sheet to avoid direct skin contact and reduce friction.
Step 3 Hang the pump over the frame or board at the foot end of the bed.
Make sure the pump is secured.
Step 4 Connect the inflation tubes from the bubble pad to the pump's inflating nozzles.
Make sure they are properly attached.

: Make sure the inflation tubes are not kinked or tucked under the pad.
CAUTION
Step 5 Plug the power cord into an electrical outlet with grounded AC power.
If the power cord has a grounding wire with a grounding pin, then this three-wire plug
must be plugged properly into an outlet and grounded as shown in the figure in the
Grounding Instructions section.

: Before inserting the plug into the outlet, make sure the voltage is compatible.
NOTE

: Make sure this product is well grounded.
CAUTION
Step 6 Turn on the power by pressing the power switch at the right side of the pump.
Proceed to the Operation section.
Step 7 Make sure to disconnect the pump by unplugging the power cord when it is not in
use.
4
REV6.12.11.14