Manual Or Automatic Switching - Vogel's SAVA 1026 Modo De Empleo

5

Manual or automatic switching

The SAVA 1026™ allows you to choose which HDMI source is
displayed on the TV. If you turn on one of the HDMI sources, it
will automatically switch to the correct input. If multiple HDMI
sources are turned on, the SAVA 1026™ will automatically switch
to the HDMI source that was activated last.
To deactivate or reactivate automatic switching, press the input
selection button on the remote control for 3 seconds. Input lights 3
and 4 will light up briefly to confirm. If you want to
manually select another HDMI
source, repeatedly press the
input selection button on the
remote control briefly until you
arrive at the right input, or use
the direct input selection
buttons (IN1 to IN4) to switch to
the required input directly. Alternatively, you can
use the "Select" button at the front of the
SAVA 1026™.
Note: Automatic switching must be supported by the HDMI
source. If it is not supported, you should manually select the
appropriate HDMI source.
10
Direct input
selection
Input
selection
© VOGEL'S