Technical Data; Troubleshooting - SpeedClean CJ-125 Instrucciones De Operacion Y Mantenimiento

CJ-125

Technical Data

SPECIFICATIONS
Motor Power
Input Power
Recharge Power
Water Requirements
Output Water Pressure
Output Water Flow
Pump
Water Tank
Soap Tank
Noise Level
Dimensions
Weight
CJ-125
PROBLEM
Inconsistent and/or
erratic pressure
Motor continues to run
even though trigger is
released
Motor stops
abruptly
Motor buzzes but fails
to start or does not start
at all
No water flow/Water
not priming
8
CJ-125 Operating and Maintenance Manual
0.2 HP
15 amps, 12V, DC rechargeable VRLA battery
Standard: 3 amps, 115/230 V, 50/60 Hz AC
On-Board
125 PSI (8.5 bar)
0.7 GPM (2.6 liters)
Positive displacement diaphragm
3.3 gallons (12.5 liters)
1.75 quarts (1.6 liters)
66 dBA
19" high x 18" wide x 10" deep (48.2 cm x 45.7 cm x 25.4 cm)
22 lbs (10 kilos) net dry; 52 lbs (24 k) at 3.3 (12.5 liters) gallons
water and 1.75 (1.6 liters) quarts chemical

Troubleshooting

PROBABLE CAUSE
• Nozzle worn
• Nozzle clogged
• Water/chemical is low
• Air sucked into system
• Air in pump (not properly primed)
• Vacuum lock (cap vent clogged)
• Water temp too high
• Low battery
• High pressure system or pump
hydraulic circuit not watertight
• Air in system
• Tank(s) empty
• Battery too low to operate
• Battery wire(s) not connected
• Power switch off
• Thermal breaker tripped
• Problems with pump auto shut-off
• Unit in disuse for extended time
• Pressure needs to be relieved
• Clogged check valve
CJ-125
REMEDY
• Replace nozzle
• Clean nozzle orifice
• Add water and/or chemical
• Fill tank(s)
• Remove nozzle, prime pump
• Clean cap air vent
• Add cold water to
reduce temp
• Charge or replace battery
• Check for leaks at spray gun
and pump
• Re-prime the unit
)
• Fill tank(s
• Charge or replace battery
• Check battery wires
• Turn switch on
• Turn off, let unit cool
• Contact factory
• Contact factory
• Squeeze trigger and relieve
pressure
• Clean out/replace the
check valve