Sears Craftsman 917.387021 Manual Del Usuario página 5

• Raise handles until lower handle section
locks into place in mowing position.
• Remove protective padding, raise upper
hat, die section into place on lower
handle and tighten both handle knobs.
° Remove handle padding holdidg
operator presence contro{, bar to upper
handle.
Your lawn mower handle can be
adjusted for your mowing comfort.
Refer to "Adjust Handle" in the Service
and Adjustments section of this manual.
J .....
KNOW YOUR LAWN MOWER ....... "
READ THIS oWNEF{'S MANtJAL AND SAFETY RULES BEFORE OPfERAT NG YOUR LAWN
MOWER. Compare the illustrations with your lawn mower tofamiliarize yourself with the '_
!ocation of vadouscont_9lsand adJusfmen!st _ save thisi_anua! for future reference.
These symbols may appear on your lawn mower or in literature supplied with the
product. L.eam and understand their meaning.
CAUTION ENGtN_ ENGINE FAST BLOW CHOKE FUEL O_L bANGER, KEEP HANDB
OR WARNING ON OFF , AND FEET AWAY
Engine zone
presence
control cable control bar
Upstop bracket
Starter handle
Handle knob
Cable clip
Engine oil cap Gasoline fill cap
with dipstick
Primer
Discharg e
guard Housing
Mulcher
plate
MEETS CPSC SAFETY REQUIREMENTS
Sears rotary walk-behind power lawn mowers conform to the safety standards of the American
National Standards Institute and the U,S. Consumer Product Safety Commission. The blade
turns when the engine is running,
Operator presence control bar- must be
held down to the handle to start the engine,
Release to stop the engine.
Primer - pumps additional fuel from the
Wheel adjuster
(on each wheel)
carburetor to the cylinder for use when starting
a cold engine,
Starter handle - used for starting the engine,
Muleher plate- Located at the discharge
opening must be removed when converting to
bagging or discharging operation.