Sears Craftsman 580.768310 Manual Del Usuario página 4

Yourpressure washer requires someassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withthe recommended oilandfuel.
If you haveanyproblemswith the assemblyof
your pressurewasher,pleasecall the pressure
washerhelplineat 1-800-222-3136.
IMPORTANT: Anyattempt t o runtheenginebefore it
hasbeenserviced withthe recommended oilwill result
in anengine failure.
REMOVE PRESSURE WASHER
FROM CARTON
• Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
• Remove fillers and parts box shipped with your
pressure washer.
• Roll the pressure washer out the open end of the
carton.
• Raise guide handle, secure in place.
Lift the handle to upright
position and slide the
locking caps into place.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
• Add oil to engine crankcase.
• Add fuel to fuel tank.
• Connect high pressure hose to the spray gun and
the pump.
• Connect water supply to the pump.
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SH, SG, or SH/CD rated SAE 30
weight.
• Place pressure washer on a level surface.
• Clean area around oil fill.
• Remove oil fill cap and dipstick.
• Wipe dipstick clean, insert it into oil fill hole and
tighten securely, remove dipstick. Add
recommended oil up to "Full" mark on dipstick.
Pour slowly. Wipe dipstick clean each time oil level
is checked. Do Not overfill.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
• The main unit
• Parts box (which includes items listed below)
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Engine oil
Owner's manual
Nozzle cleaning kit
O-Ring maintenance kit
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 6. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• Install oil fill plug and dipstick, tighten securely.
NOTE: Check oil often during engine break-in.