Fan Speed; Other Indications - Essick EP9 500 Manual Del Propietário

... , .
• °
• . . •••
"FAN SPEED
2)
The Speed button controls
the variable speed motor.
Nine speeds provide precise
fan controLPress the power
button and select fan speed:
F1 through F9 proceeding
from low to high speed.
The fan speed will display on
the control panel as the
speeds are stepped through.
Press.Speedbut[on
to increasespeed•
t
Fan Speed (F1-Fg) Will Display
NOTE: When excessive condensation exists, a lower fan speed setting is
recommended•
HUMIDITY CONTROL
NOTE:.The EP9 500 / EP9R 500 units have an automatic humidistat located on the
cord that measur.es the relative humidity in the room• When the selected humidity
level drops 3% below the relative humidity, the humidifier cycles on and off as ..
required to maintain the selected setting.
Press Humidity
increase
humidity setting
Displays Relative humidity at star_-up,
steps through Humidity Lever Selection (in 5% increments),
then•returns to Relative Humidity after setting is eemplete.. "
3)
At initial startup the
relative humidity of
the room will be
displayed.
Each successive
push of the Humidity
Control Button will
increase the setting
in 5% increments• At
65% set point, the
unff will opera.te
contiriuously•
.°
OTHER INDICATIONS
This humidifier has a check filter reminder, timed to appear after
•720 hours of operation. Whenthe Check Filter (CF) message is
displayed, disconnect the power cord and check the condition of
the filter• The CF function is reset after plugging the unit back in.
5)
When the unit is out of water, a flashing F will display on the display
panel.
m
Check Filter
Function Display
A Flashing F indicates
the unit needs to be filled•
• . ,o
• . • , •
. . ,° °°