En] Parallel, Three, Split-Phase Systems - Victron energy VictronConnect VE.Bus Guía De Configuración

12.

[en] Parallel, Three, Split-phase systems

[en] Until now our VE.Bus Quick Configure software was required to set up a complex VE.Bus System. This is not the case any-
more as VictronConnect can now be used to configure systems of up to three units.
[en] Watch this video where we demonstrate
[en] Please note a password is required for this feature, the password is available from your Victron supplier.
???
[en] VictronConnect allows you to change the settings of each individual MultiPlus/Quattro in an existing system. And to copy set-
tings from one of the inverters to the rest; as well as saving the settings of all the units to a file.
[en] Supported features and limitations:
• [en] Set up Parallel, Three phase and Split phase systems. (Limited to a max of three units)
• [en] Configure existing systems of up to twelve or fifteen units – depending on the inverter/charger model.
• [en] Copy settings from one unit to the rest.
• [en] Save the complete system configuration to a file for future use on a similar system, and as a backup.
• [en] Assistants are removed when setting up a new system.
• [en] Firmware updating is proposed automatically when setting up a new VE.Bus system.
VictronConnect - Guía de configuración VE.Bus
all steps involved in configuring a three phase system in just a few clicks.
24