Evolv Avatar RS 200W Manual De Instrucciones página 25

he right or DNA200, the OLED display will show "NO ATOMIZER".
onfirm the • Battery level: the OLED display shows a battery symbol.
press the • Temperature of AVATAR RS DNA200: if the temperature of the device exceeds the
once again optimal, the AVATAR RS DNA200 immediately stops delivering power and the display will
show "DEVICE TOO HOT". The product can be used after returning to the ideal operating
the button temperature.
AVATAR RS DNA200 BATTERY
ew resist-
the trian-
The battery of the electronic cigarette AVATAR RS DNA200 is an integrated structure con-
e pointing
sisting of an outer metal casing, an integrated 3 cell Lithium Polymer battery of 1,500 mAh
(about 3,900 mAh Li-Ion), DNA200 circuit, an OLED screen which shows the remaining
To change
battery power, voltage, wattage, temperature control and impedance (ohm) of the screwed
e pointing
cartomizer, a round fire button in steel, a button with the triangle pointing to the left, a
profiles. To
button with the triangle pointing to the right, a micro-USB input port for charging the bat-
tery and a 510 connector for cartomizers. The electronic cigarette AVATAR RS DNA200 can
erature of
select wattage (from 1W to 200W) and temperature control (100 ° -300 ° C or 200 ° -600
determine
° F). The choice of wattage determines the power of the battery supply to the cartomizer.
ectly from
The temperature control defines, instead, the specific temperature at which you want to
S AVATAR
use the device with a specific resistance (the Temperature control mode can only and ex-
clusively be used with resistors in Ni200, Ti and other wires in the market that are compat-
circuit, the
ible with Temperature control mode). Make sure that the impedance (ohm) of cartomizers
used with this battery is fair to the temperature or the selected wattage. The AVATAR RS
VATAR RS
DNA200 battery shuts down and remains in stand by automatically when not in use.
MANUAL_RS200W.indd 25 13/10/16 16:23