Gabarron ECOMBI ECO158 Instrucciones De Instalacion Y Uso página 17

10.- Place the heating elements back into their original position. Place the other two rows of storage bricks with the flat side
facing out and always on the heating elements supporting tabs.
11.- Replace the inner front panel. If the bricks have been fitted correctly you will have no difficulty in replacing the panel. Make
sure the bottom edge of the inner panel is inside the front lip of the heater. Please see below:
12.- Connect again the two fast-on connectors to the aluminum heating element attached to the inner panel at both ends.
13.- When replacing the outer front panel, align the 2 plastic upper pegs on the heater with the holes in the outer panel. Push
the top up into place and push the bottom in until it rests on the plastic feet.
14.- Replace the front panel with screws.
RELOCATION
WARNING: Relocation to another location must be carried out by an experienced technician.
If during reinstallation the thermal insulation shows any sign of damage, it must be removed and replaced by an identical part.
MANUALLY RESET TEMPERATURE LIMITER
This heater employs a manually reset temperature limiter (see LR in the connection diagram).
This safety device operates when high temperatures are reached at the top of the heater. It requires re-setting manually:
Let the heater cool. The cause of overheating should be investigated.
WARNING: Re-setting manually must be carried out only by an experienced technician.
Turn off the heater at the circuit breaker.
Take off the front panel by removing the two screws located at the bottom. Find the limiter at the top of the inner panel behind
the grill and push the small pin until a click is heard.
RIGHT
POSSITION
17
WRONG
POSSITION