Cadet NLW Serie Guia De Inicio Rapido página 5

WARNING Risk of Electrical Shock and Fire.
The heater must be properly installed before it is
used.
1. Do not operate without grill.
2. Keep electrical cords, drapery, furnishings and
other combustibles at least 3 feet away from the
front of the heater and 6 inches away from the
sides.
3. Do not tamper with the over temperature limit
control.
4. If the heater over temperature limit trips more
than once per day, the heater must be replaced.
Fan cycling with heat
The room temperature is controlled by a line voltage thermo-
stat built-in to the heater.
1. Turn fan switch to the "AUTO" position and turn the ther-
mostat knob fully clockwise.
2. When the room reaches your comfort level, turn the ther-
mostat knob counterclockwise until the heater turns off. The
heat and the fan will automatically cycle around this preset
temperature.
3. To reduce the room temperature, turn the knob counter-
clockwise. To increase the room temperature, turn the knob
clockwise.
About the Manual Reset Temperature Limit Control
The heater is protected by a temperature-limiting control. The manual reset temperature limit control is designed to open the heater
circuit when excessive operating temperatures are detected. The problem must be assessed and the limit must be reset to resume
operation.
Resetting the Manual Reset Temperature Limit Control
If the manual reset limit control has opened the heater circuit due to excessive
operating temperatures, the heater will not work until the limit reset button is pressed.
After allowing the unit to cool for at least 10 minutes, turn the electrical power off at
the electrical panel board (circuit breaker or fuse box) and remove the grill. Once the
problem causing the limit to trip has been resolved (typically the heater is blocked or
needs cleaning), push button located on the heat box. Press FIRMLY, and be sure to
listen and feel for a click, indicating it has been reset.
For more effective and safer operation and to prolong the life of
the heater, read the Owner's Guide and follow the maintenance
instructions. Failure to properly maintain the heater will void any
warranty and may cause the heater to function improperly. War-
ranties are non transferable and apply to original consumer only.
Warranty terms are set out below.
LIMITED TWO-YEAR WARRANTY: Cadet will repair or replace
any NLW heater found to be defective within two years after the
date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper installation or
incorrect supply voltage;
2. Damage occurs to the product through improper maintenance,
misuse, abuse, accident, or alteration;
3. The product is serviced by anyone other than Cadet;
4. If the date of manufacture of the product cannot be deter-
mined;
5. If the product is damaged during shipping through no fault of
Cadet.
6. CADET'S WARRANTY IS LIMITED TO REPAIR OR RE-
PLACEMENT AS SET OUT HEREIN. CADET SHALL NOT BE
LIABLE FOR DAMAGES SUCH AS PROPERTY DAMAGE OR
FOR CONSEQUENTIAL DAMAGES AND/OR INCIDENTAL EX-
PENSES RESULTING FROM BREACH OF THESE WRITTEN
WARRANTIES OR ANY EXPRESS OR IMPLIED WARRANTY.
OPERATING INSTRUCTIONS
How to Operate Your Heater
Fan running continuously with intermittent heat
Determined by the thermostat setting
1. Turn the fan switch to the "FAN" position and turn
the thermostat knob fully clockwise.
2. When the room reaches your comfort level, turn
the thermostat knob counterclockwise until the heater
turns off. The heater will automatically cycle around
this preset temperature, however the fan will run con-
stantly.
3. To reduce the room temperature, turn the knob
counterclockwise. To increase the room temperature,
turn the knob clockwise.
Resetting the Manual Reset Limit Control
Warranty
5. Clean heater at least every six months.
6. After allowing the heater to cool, turn power off
at circuit breaker panel before removing grill.
7. Use a hair dryer or vacuum on blow cycle to
blow debris through the top element (do not touch
element).
8. Install the grill before turning on power.
WARNING: Any other service not detailed in
this Owner's Guide should be performed by an
authorized service representative.
7. IN THE EVENT CADET ELECTS TO REPLACE ANY PART
OF YOUR CADET PRODUCT, THE REPLACEMENT PARTS
ARE SUBJECT TO THE SAME WARRANTIES AS THE PROD-
UCT. THE INSTALLATION OF REPLACEMENT PARTS DOES
NOT MODIFY OR EXTEND THE UNDERLYING WARRANTIES.
REPLACEMENT OR REPAIR OF ANY CADET PRODUCT OR
PART DOES NOT CREATE ANY NEW WARRANTIES.
8. These warranties give you specific legal rights, and you may
also have other rights which vary from state to state. Cadet nei-
ther assumes, nor authorizes anyone to assume for it, any other
obligation or liability in connection with its products other than as
set out herein.
If you believe your Cadet product is defective, please contact
Cadet Manufacturing Co. at 360-693-2505, during the warranty
period, for instructions on how to have the repair or replacement
processed. Warranty claims made after the warranty period has
expired will be denied. Products returned without authorization
will be refused.
Parts and Service
Visit http://www.cadetheat.com/parts_service.php for information
on where to obtain parts and service.
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You
can reduce your carbon footprint by recycling this product at
the end of its useful life. Contact your local recycling support
center for further recycling instructions.
Fan running
continuously
with no heat
1. Turn the fan
switch to the
"FAN" position.
2. Turn the
thermostat
knob just
above the
"OFF" position.
Manual
Reset
Limit
Button
Page 5