Dri-Eaz VORTEX F174 Guia De Inicio Rapido página 2

connect straps plus a snap-in ring used to fasten two sections
of ducting together.
Confined Space Ventilation
Position the Vortex at least five feet away from the entry to the
confined space. Place it upwind so that purged gases do not
re-enter the unit. Make sure the the inlet is not blocked by a
wall or other obstruction.
Place the other end of the ducting in the confined space, an-
gled so it points at an end wall. Keep it pointed at an end wall
to prevent pockets of unmoving air, and to keep fresh air circu-
lating to all locations.
MAINTENANCE
CAUTION: Internal repair procedures should be per-
formed by a qualified technician from an authorized
service center.
WARNING: Disconnect from electrical supply prior to
servicing or cleaning.
Cord Inspection: Inspect the electrical cord for damage. Units
with damaged cords must be removed from service and re-
paired before use. Failure to do so may lead to electrical shock
or a fire hazard.
07-00211E F174 F174-BLU
Exterior Inspection: Evaluate exterior components and make
sure that all are in proper operating condition. Repair or re-
place components as required. Run the unit briefly; listen for
abnormal sounds and repair as needed.
Clean Exterior: Clean the exterior plastic housing with mild
detergent and water. For deep cleaning and a lasting, protec-
tive shine, use a vinyl cleaner and protectant.
Motor Bearings: The bearings on the Dri-Eaz Vortex are per-
manently lubricated. No oiling is necessary.
For parts and service, contact your local Dri-Eaz distributor
SPECIFICATIONS
Power:
Amps:
Dimensions
(D × W × H)
Weight:
Motor rating:
Fan speed:
Max. static pressure:
Cord length:
Control:
Safety
Specifications are subject to change without notice.
Some values may be approximate.
.
2
115 volts / 60 Hz
7.4 amps
18 × 15 × 19 in.
24.6 × 26.2 × 18.2 in.
33 lbs. | 15 kg
1.0 hp
3520 RPM
3.0 in. H O
2
20 ft. | 6.1 m
1 speed toggle switch
UL/ULc
Dri-Eaz Products, Inc.