Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATE
YOUR SAW SAFELY
• Do not operate a chain saw with one
hand. Serious injury to the operator,
helpers, bystanders
or any combina-
tion of these persons may result from
one-handed
operation.
A chain saw
is intended for two-handed
use.
• Operate the chain saw only in a well-
ventilated
outdoor area.
• Do not operate saw from a ladder or
in a tree.
• Make sure the chain will not make
contact with any object while starting
the engine. Never try to start the saw
when the guide bar is in a cut.
• Do not put pressure
on the saw at
the end of the cut. Applying
pressure
can cause you to lose control when
the cut is completed.
• Stop engine before setting saw
down.
• Hand carry saw only when engine is
stopped. Carry with muffler away
from body; guide bar & chain project-
ing behind you; guide bar preferably
covered with a scabbard.
• Do not operate a chain saw that is
damaged,
improperly
adjusted,
or
not completely
and securely
as-
sembled.
Always replace bar, chain,
hand guard, or chain brake immedi-
ately if it becomes
damaged,
broken
or is otherwise
removed.
MAINTAIN
YOUR
SAW
IN
GOOD
WORKING
ORDER
• Have all chain saw service per-
formed by a qualified service dealer
with the exception
of the items listed
in the MAINTENANCE section of this
manual.
• Make certain the saw chain stops
moving when the throttle trigger is
released.
For correction,
refer to
CARBURETOR ADJUSTMENT.
• Keep the handles dry, clean, and
free from oil or fuel mixture.
• Keep caps and fasteners
securely
tightened.
• Nonconforming
replacement compo-
nents or the removal of safety devices
may cause damage to the unit and
possible injury to the operator or by-
standers. Use only Craftsman acces-
sories and replacement parts as rec-
ommended.
Never modify your saw.
• Maintain
chain saw with care.
• Keep unit sharp and clean for better
and safer performance.
• Follow instructions
for lubricating
and
changing
accessories.
• Check for damaged parts. Before fur-
ther use of the chain saw, a guard or
other part that is damaged should be
carefully checked to determine that it
will operate properly and perform its
intended function. Check for alignment
of moving parts, binding of moving
parts, breakage of parts, mounting and
any other conditions that may affect its
operation. A guard or other part that is
damaged should be properly repaired
or replaced by a Sears Service Center
unless otherwise indicated elsewhere
in the instruction manual.
• When not in use, chain saws should
be stored in a dry, high or locked-up
place out of the reach of children.
• When storing saw, use a scabbard
or
carrying case.
HANDLE
FUEL WITH CAUTION
• Do not smoke while handling fuel or
while operating the saw.
• Eliminate all sources
of sparks or
flame in the areas where fuel is
mixed or poured.
• Mix and pour fuel in an outdoor area
and use an approved,
marked con-
tainer for all fuel purposes. Wipe up
all fuel spills before starting saw.
• Move at least 10 feet (3 meters) from
fueling site before starting engine.
• Turn the engine off and let saw cool
in a non-combustible
area, not on
dry leaves, straw, paper, etc. Slowly
remove fuel cap and refuel unit.
• Store the unit and fuel in an area
where fuel vapors cannot reach
sparks or open flames from water
heaters, electric motors or switches,
furnaces,
etc.
GUARD AGAINST
KICKBACK
Follow all safety rules to help avoid
kickback and other forces which can
result in serious injury.
%\
Kickback Path
Publicidad
Tabla de contenido
