Getting Started - Shure ANI22 Guia Del Usuario

Getting Started

This device features a browser-based web application, which controls audio and network
properties. Upon completing this basic setup process, you will be able to:
• Access the web application to customize audio settings and network properties
• Use Dante™ Controller software to connect with other Dante devices and pass audio
• Access additional configuration information
Step 1: Connect to a Network
1. Use an Ethernet cable (CAT5e or higher) to connect the ANI22 to a network switch.
Note: The network switch must provide Power over Ethernet (PoE). Make sure to connect to
a PoE port, since many switches do not supply power on all ports.
2. Connect a computer to the network switch with an Ethernet cable
INPUT
OUTPUT
sig/clip 1 1
in1 power
in2 network
out1 network audio
2 2
out2 encryption
ANI22
Step 2: Access the Web Application
1. Download and install the Shure Device Discovery application (http://www.shure.com)
2. Open the Shure Device Discovery application
3. Double-click the device to open the web application.
Tip: If setting up multiple Shure devices, use the Identify button in the application to flash the
lights on the device.
Select the device
PoE
reset
Network Switch
3
Computer
Identify