Connecting The Antenna; Preparing The Remote Control; Connecting The Headphones; Setting The Basic Functions - Sonoro SO-310 Instrucciones De Manejo

Ocultar thumbs Ver también para SO-310:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

L WARNING!
Risk of injury if handled incorrectly!
Risk of electric shock if the mains cable is handled
incorrectly.
– Pull the mains cable straight out of the outlet.
L NOTICE!
Risk of damage to equipment in the event of
incorrect power connection!
Connection ratings that exceed the maximum per-
missible values of the device can destroy it.
– Only use the mains cable supplied with the
device.
– Only use the device if the indicated voltage cor-
responds with the voltage of your mains socket.
1.
Insert the plug of the mains cable into the
power socket on the back of the device.
2.
Insert the mains plug in the outlet.
7.4

Connecting the antenna

Fig. 8: Connecting the antenna
The included antenna is needed for radio reception in
the FM frequency range and for DAB radio stations.
1.
Screw the included FM/DAB antenna on the
back of the device to the DAB/FM antenna con-
nector.
2.
Unfold and align the supplied FM/DAB antenna
to obtain optimum reception.
52
i
For good FM/DAB radio reception, the two ends of
the antenna should form a "T" (dipole) with the
connecting cable (Fig. 8).
For even better reception, attach the cable to a
suitable house antenna.
7.5

Preparing the remote control

Fig. 9: Inserting the battery in the remote control
1.
Open the battery compartment of the remote
control (Fig. 9).
2.
Insert the supplied button celle (CR2032, 3 V)
with the label side (+) up.
3.
Close the battery compartment.
7.6

Connecting the headphones

Headphones with a 3.5 mm jack plug (not supplied)
can be connected to the device.
L WARNING!
Risk of injury if headphones are used incorrectly!
Incorrect use of headphones can cause severe
accidents and damage your health.
– When you are using the headphones, do not
set an excessively high volume.
1.
Turn the click wheel to the left to set the volume
to minimum.
2.
Insert the headphone jack plug into the port on
the back of the device.
3.
Slowly turn the click wheel to the right to
increase the volume.

8 Setting the basic functions

The individual menus let you select the functions and
settings of the device.
© 2013

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido