Dometic Fan-Tastic 3300 Manual De Instalación Y Funcionamiento página 13

Fan-Tastic Vent Fan
3. From the interior of the RV, use four #8 flat-head
screws (not provided) to mount the trim garnish
into the fan base. Do not overtighten the screws.
See "Trim Garnish Dimensions" on page 6 for
recommended screw length.
I The four screw holes are located on the inside
corners of the shorter trim garnish (not provided).
4. Using a screw gun, torque the #10 flat-head screws
equally. Do not overtighten.
I If using sealant, for rubber roofs, use an EPDM-
compatible roof sealant.
3 .7 Mounting the Controls
This section describes how to install your vent fan controls.
3 .7 .1 Mounting the Remote Control
Cradle
This section describes two options to install a cradle
for those models equipped with a remote control. The
cradle installation is optional.
q
KK
(Front)
15 Remote Control Cradle
#8 x 3/8" screws
q
• Option 1: Hold the back of the cradle (KK) to the wall
location and secure it with two #8 x 3/8" screws (not
included) through the two round holes in the back.
• Option 2: Affix the cradle (KK) to the wall location
using a removable, hanging strip (not included) that
is safe for your RV interior according to your owner's
manual.
EN
w
(Rear)
Removable Hanging Strip
w
3 .7 .2 Mounting the Wall Controls
q
r
t
16 Wall Control
Notch
q
RJ-11 control cable
w
KK
#8 x 3/8" screws
e
1. Locate the notch on the bottom edge of the wall
control (NN) and use a screwdriver or a coin in a
twisting motion to separate the back plate.
2. Thread the RJ-11 control cable (in the wall) through the
square hole in the back plate (from the backside to
the front) and plug it into the front half of the control.
3. Hold the back plate to the wall location and secure it
with two #8 x 3/8" screws (not included) through the
two round holes in the back plate.
Installation
w
e
r
Front
r
Back
t
NN
t
13