Blaupunkt WiFi LampCam HOS-X20 Manual De Instrucciones página 6

3.4. LampCam Installation
IMPORTANT:
Setup and installation of the LampCam should
only be performed by a person with adequate
knowledge in handling electricity power.
DO NOT attempt installation if you do not
possess required skill.
Step 1:
Please make sure you have turned OFF the power
from the circuit breaker before this step.
1
Off
Step 2:
Find the desired installation location for the
LampCam. The installation location needs to have
220V AC wires (grounding, phase and neutral wire).
(e.g. of a previously installed Outdoor Lamp.)
Step 3:
Place the included installation positioning map on
the wall and mark with a pencil the two holes that
need to be drilled.
Step 4:
Drill the 2 mounting holes on the wall. Take
the plastic dowels included in the installation
accessories set and insert them into the 2 holes that
where just drilled.
Step 5:
Perforate a small hole with a sharp object at
A
position in the rubber pad and lead the AC
wires from the wall through the back of the
mounting bracket to the terminal blocks.
6
5
A
Step 6:
Lead the AC wires from the wall through the back
of mounting bracket and connect them in the
following way:
- Phase wire (brown) to terminal block
with brown cable.
- Neutral wire (blue) to terminal block
with blue cable.
- Protective earth wire (Yellow/Green): Leave it
hanging out, it will be connected in Step 8.
Now place the terminal block back into the
mounting bracket.
6
terminal blocks
Step 7:
Take the screws included in the installation
accessories set and fasten the mounting bracket to
the wall. Make sure that the "UP" sign is at the top.
7
Up
Up