Craftsman 315.CG1150 Manual De Operacións página 10

STEP 4: ATTACHING FIREBOX HANDLE
See Figures 11 - 12.
 Raise and open the stand.
 Lift the hood latch then raise firebox hood.
 Insert studs in firebox handle (A) through holes in
firebox hood.
 Install wing nuts (AA) and tighten securely.
FIREBOX
HANDLE
WING
NUT
FIREBOX
ASSEMBLY
FIREBOX
HOOD
Fig. 11
HOOD
LATCH
FIREBOX
HOOD
Fig. 12
10 — English
STEP 5: INSTALLING THE GREASE CUP
See Figure 13.
 Slide the grease cup (B) into the brackets on the
bottom of the grill.
NOTE: Clean the grease cup after each use. Do not
remove the grease cup until after the grill has cooled
completely. Do not transport the grill with a dirty grease
cup.
GREASE
CUP
STEP 6: INSTALLING BATTERY IN IGNITOR
See Figure 14.
 Turn the ignitor cap counterclockwise and lift cap from
the control panel.
 Slide a AAA battery (CC), negative (—) end first, into
the ignitor. Be sure spring is still in place inside the
ignitor cap.
 Replace ignitor cap.
Fig. 13
IGNITOR CAP
AAA
BATTERY
Fig. 14