Beta 1895 6 Instrucciones De Uso página 13

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
OPERATION GUIDELINES
Step
Select your cleaning solution: fill at least ½ of the tank with the solution. Do not exceed the filling line.
1° NOTE: Do not use alcohol, petrol or flammable solutions. Doing so could cause a fire or explosion.
Use only water-based solutions.
Place the items into the basket; then slowly lower the basket into the tank. Do not allow the items to
2°
contact the tank bottom (the solution should cover the items).
Plug the cleaner into a grounded outlet.
Power on and turn on the power switch on the back side of the cleaner.
3°
NOTE: When the device is powered on, the room temperature will be displayed. The default time and
temperature are those you set last time. (3 minutes' default time for initial use).
Press + / - to set the cleaning time. When the timer counts down to 00:00, the ultrasonic cleaner will
Timer
stop working.
The cleaning time depends on the conditions of the item to clean, the type of detergent used and
temperature. Cleaning cycles of 15÷30 minutes are usually enough to clean the items properly.
NOTE: The device comes with the memory function and acquiesces in the time you set last time.
Press the "Heating" key to start or stop heating. Press + / - to set the temperature.
1) To get the best cleaning result, the recommended solution temperature is 40÷60 °C. Warm water
and detergent will soften grease and improve the cleaning result.
2) When setting the temperature, if the set temperature exceeds the room temperature, press the
"Heating" key. Heating will be started and the indicator will turn on.
Heating
If the set temperature is lower than the room temperature, heating will not be started, and the indicator
will not turn on.
3) Heating will not shut off automatically; press the "Heating" key.
NOTE: The device comes with the memory function and acquiesces in the temperature you set last
time.
After the timer and temperature have been set, press "Degas". The corresponding indicator will go on,
and the device will work in "Degas" mode:
- It will work for 6 seconds, stop for 2 seconds, then work for 6 seconds etc.
The countdown will be displayed.
The intermittent operation of ultrasonic power results in quicker degassing of the cleaning liquid.
Degas mode
After the air bubbles have been removed from the cleaning liquid, to change mode, press "Soft" or
"Normal". The "Degas" indicator will turn off, and the indicator for the "Soft" or "Normal" mode will
turn on.
If you want to stop working, just press "Soft" or "Normal" again. Both heating and ultrasonic cleaning
will stop, and the corresponding indicator will turn off.
Action
EN I
13