Getting To Know Your Unit; Set Up Instructions - Campbell Hausfeld XT401000 Manual De Instrucciones

GETTING TO KNOW YOUR UNIT

Chuck
Sleeve

SET UP INSTRUCTIONS

* Items shown in Set Up Instructions are not included with this tool.
u The air compressor used with your reversible drill must be able to maintain a
minimum of 90 PSI when the tool is being used. An inadequate air supply can
cause a loss of power and inconsistent tool output/performance.
u A pressure regulator—used at the tool--is helpful to control the operating pressure
of the tool and maintain 90 PSI.
u Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
u To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
u Make sure that the bits used with your pneumatic drill are heat-treated steel for
increased durability and longer life.
Ring
Trigger
Forward/Reverse
Switch
Air Hose
BEST PRACTICES
3
Exhaust Port
Plug
Quick
Coupler
Air Inlet