Start Up - Truper DES-440T Manual Del Usuario

B
G
Upper
section
Lower
section
D
8
ENGLISH
B
Notch
Turning on
• Connect one end of the extension cable into the brush cutter power plug (E).
Using an ERA-8X16
• Fasten the extension through the cable fastener (F).
• Stretch out the extension cable and connect into a power outlet with the voltage
specified for the brush trimmer.
• To start the brush trimmer, release the trigger lock (G). Then, press the trigger
switch (H). To turn off release the trigger switch.
F
E
Assembly
Cutting string spool
• The trimmer shall be off and disconnected. Remove the
spool-retaining cap (B) pressing towards the side tabs.
Pull the cap upward.
• Remove the empty spool. Double check is clean and has
no damaged or worn parts.
• Cut a line of thread up to 197".
• Bend the line to the middle of the length and insert in
the notch (C).
• Hold both lines and spin in the direction indicated in the
spool with an arrow. Double check each length of line is
spun in their respective section (upper and lower). Do not
spin too much line. After spinning there shall be a
minimum 1/4" distance between the spool edge and the
spun line.
• Leave a length of approximately 6" of both lines. Insert
the line from the upper section in one of the notches in
the spool cover. Give the spool another half-a-turn and
insert the lower section line in the opposite notch in the
spool cover.
This is done to prevent the line to get loose while
installing the spool in the brush trimmer. Later, you will
release the lines from the notches.
• Set back the spool in the cutting head (D). Pass the ends
of each line through the cover orifices. If in this step, the
line gets released or tangled spin it again in the spool and
secure it in the notches.
• Pull hard and outward both cutting
CAUTION
string ends to release them from the grooves in the spool
upper part.
• When installing a new spool release the ends of the line
from the notches and unroll approximately 6" of both lines
to secure them back in the notches before setting the spool
in its cover.

Start up

brand extension cable is recommended.
G
H