Rear Panel - Denon Professional DN-333XAB Guia Del Usuario

Rear Panel

1
3 4 5
1. Power Input: Use the included power cable to connect this input to a power outlet. Make
sure DN-333XAB's power switch is set to "off" when connecting or disconnecting the
cable.
2. Bluetooth Antenna: The antenna receives and transmits the Bluetooth signal from a
paired Bluetooth device. DN-333XAB has a range of up to 100 feet (30.5 meters).
3. Alarm On: This sends DN-333XAB's alarm tone to your external speakers (to alert guests
to an emergency situation). See
4. Chime On: This sends DN-333XAB's chime tone to your external speakers (as a "pre-
announcement" before paging). See
5. Mic 1 Priority: This sends DN-333XAB's Mic Input 1 signal to your external speakers
(muting the sound from the other inputs). See
6. Speaker Out: These outputs send the main/master signal from DN-333XAB to your
external speakers. Connect these outputs to your speakers using a properly wired 4-pin
Euroblock connector and speaker wire. The power of each output is less than 120 W
(without distortion). Use only one output at a time. See
7. Mic Inputs: Connect microphones to these inputs using standard XLR or 1/4" (6.3mm)
TRS cables. Turn the Mic In Level knobs on the front panel to control their volume levels.
8. Phantom +15V: Press this button to activate or deactivate +15V phantom power for any
microphones connected to the mic inputs. When activated, the light above the button will
turn on.
Note: Dynamic microphones usually do not require phantom power, while condenser
microphones usually do. Consult your microphone's documentation to find out whether it
needs phantom power. Deactivate phantom power if your microphones do not require it.
9. Line Inputs: Connect line-level audio devices to these inputs using standard stereo RCA
cables. Turn the Line In Level knobs on the front panel to control their volume levels.
10. Aux Out: Connect an external speaker or mixer to these outputs using standard stereo
RCA cables. When an audio device is connected to the aux input on the front panel, its
signal will be sent to these outputs. Turn the BT/Aux In Level knob on the front panel to
control its volume level.
CHIME MIC 1
ALARM
ON ON PRIORITY
6
Setup
9
7
10
for more information.
Setup for more information.
Setup for more information.
Setup
2
7 7
PRIORITY
8
for more information.
5