Nowsonic LAN 19 Manual De Usario página 11

Stage Router Pro
EN
User manual
L2TP
•
Depending on your selection, you will then have to enter the required login data (PPPoE: user name, password) and confirm your selection with
■
Apply.
Next, configure the radio band for the wireless network. Set the following preferences in the 2.4 GHz Wireless Setting field:
■
SSID on/off: Choose the Enable option here to assign a specific name to the Nowsonic Stage Router Pro.
•
SSID: Enter a specific name or accept the default name here. This name is displayed when other devices are scanning the local network.
•
Encryption: You can choose an encryption method for your wireless network here. To ensure fail-safe operation, we recommend the WPA2
•
Mixed option here. If you set an encryption key, please write down the key to allow other wireless devices to connect with your wireless LAN
later on.
NOTE: Without an encryption key, unauthorized users can connect to the wireless network of the Stage Router Pro and manipulate the remote
control of the digital mixer. We therefore highly recommend encrypting your network access.
Finally, click Apply. The Stage Router Pro is now configured as an access point for operation with a digital mixer and a mobile device.
■
If you want to use the 5 GHz radio band additionally or as an alternative, adjust the settings in the 5G Wireless Setting field to the sample de-
scribed above: The parameters and procedure are identical.
If you want to use multimedia services with the Stage Router Pro, for example to share data on a USB mass storage device on the network, you
also need to set up the IPTV Settings section. To do this, proceed as follows:
IPTV On/Off: Select the Enable option here to use the service.
•
IPTV Tag: Activate this option.
•
IPTV VID: Enter the VLAN ID here.
•
IPTV Port: Activate the desired port(s) to be made available via IPTV here.
•
Finally, click Apply. Set-up is now complete.
■
Wait until the Stage Router Pro has established a connection with the network: Once the registration has successfully completed, a dialog box will
appear. Confirm this with Finish. The Router Status Interface will then be displayed, showing the selected protocol (e.g. PPPoE) and the IP and
DNS settings.
11
www.nowsonic.com