Technaxx TX–39 Manual De Usuario página 6

Attention: In case a NEW version of MY FITNESS is available, you MUST (!) uninstall the
old version first, before you install the new version on your mobile device!
To save power consumption, the Bluetooth connection between the wristband and
the mobile device will turn off automatically after each synchronization.
ATTENTION: If the Bluetooth connection was not successfully with your mobile
device, you must use the 3.5mm jack cable to synchronize! Simply connect it with
the 3.5mm Earphone jack of your mobile device and the other end with your
wristband. Then synchronize again.
5.2. Sync via 3.5mm jack (only for Android version, not for iOS version)
(a) Tab the button shortly two times continuously to enter into SYNC selection mode.
Choose 3.5mm SYNC. .
(b) Insert the supplied 3.5mm plug into the earphone jack of your phone. The APP will
indicate "Audio jack is connected, begin to sync" and "sync finished". Do not withdraw the
3.5mm plug while synchronizing.
(c) Pull out the 3.5mm plug after synchronization is completed.
ATTENTION: When, after several tries of synchronization, the key icon still is
unlocked, you have to repeat the steps 5.1 or 5.2 !
6. Anti-loss function
6.1 Switch the wristband to the Bluetooth mode.
6.2. In the APP tap on the icon for "Anti-loss mode".
6.3. The word "SEARCH" shortly is been displayed; after 10–15 seconds you are
connected to the "Anit-loss mode".
In case you forget to take you mobile device (e.g. your Smartphone) with you and you are
going away, in a distance of approx. 5m the Bluetooth connection between your mobile
device and your wristband is decreasing; in a distance of approx. 20m your wristband give
a vibrating alarm; this indicates that you do NOT have your mobile device with you.
The "Anti-loss mode" only gives you a vibrating alarm which indicates the LOSS of your
mobile device, it does not tell you, where you lost it.
6.4. In the APP tap on the icon "Back" to leave the "Anti-loss mode" the wristband is
vibrating shortly.