Application; Disassembly; Assembly - Laevo V2.57 Instrucciones De Uso

2

Application

These parts are meant only to be used in a complete
LAEVO V2 exoskeleton:
1. Check if all parts are supplied (Figure 2.1)
2.
Check the LAEVO revision number on the label on the
inside of the SmartJoint. Use these Legpads only with
the following serial numbers: V2.57xxxx (x can be any
number).
3

Disassembly

1.
Remove the two bolts with the supplied hex key
(Figure 3.1).
2.
Slide the Legpad out of the SmartJoint (Figure 3.2).
4

Assembly

6
CAUTION:
Legpad and the SmartJoint, immediately stop using
the product.
2
NOTICE: Installation has to be done by a qualified
person. Not comfortable with bolts or screws? Let
someone else handle it.
1.
Remove all packaging and tape from the Legpads and
bolts.
2.
Slide the left Legpad into the left SmartJoint (Figure
4.1).
When noticing any slack between the
Laevo | V2.57 LEGPAD EN | P6