Publicidad
Idiomas disponibles
Idiomas disponibles
Series E400, E500, LFE400 and LFE500
Kitchen Faucets
Installation Instructions
1
Shut off hot and cold water supply under
sink. Plug sink drain with cloth to avoid
losing small parts. Remove old faucet.
4
Insert threaded end of spray hose down
through hose guide. Attach to faucet. Pass
hose through center hole in sealing gasket
and attach to center faucet outlet, tightening
securely. Note: Use pipe joint compound
or plumbers tape on this connection.
Limited Warranty: Watts Regulator Co. (the "Company") warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date
of original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER WAR-
RANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, spe-
cial or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs result-
ing from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has
no control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws
to determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
B r a s s & T u b u l a r P r o d u c t s
IS-E400/E500 0845
2
Place plastic plate on bottom of faucet
smooth side down. For models without
spray, proceed to step 5.
Refer to this if unit is
a two handle faucet
5
Set faucet in place on sink. From underneath
sink, put washers and lock nuts on finger tight.
Position faucet on sink properly and tighten nuts
with basin wrench or adjustable wrench.
7
Connect hot and cold water supplies.
Use pipe compound or plumber's tape when
attaching faucet to water lines.
USA: 815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com
Canada: 5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca
EDP# 1915396
IS-E400/E500
3
Place spray hose guide in far right hole
of sink and attach washer and locknut
from under sink.
Refer to this if unit is
a single handle faucet
6
Note: If faucet supply lines need to be bent,
grip tube at point of bend with right hand,
firmly and slowly pull tube into position using
rounded bend with left hand. Extreme care must
be exercised. Follow instructions exactly.
8
Turn on hot and cold water. Check for any
leaks, especially at connections to supply
lines. Remove aerator from end of spout. Flush
both water lines allowing water to run for one
minute. Replace aerator.
© Watts, 2008
Publicidad
