Cleaning And Maintenance - Gabarron RX4P Instrucciones De Instalacion Y Uso

WEEKLY PROGRAMMES
It is possible to allocate different programs to different days of the week. T o do this, the controller has to be upgrade from 24hr mode (factory
default) to 24hr/7days mode as follows:
0
Move the selector to position, the display will be Off. Press the
key at least five seconds. The display will show
SETTING THE DAY: Press the
–
+
by pressing or keys. Press the
To check a programme or to make a new one press
00:00
show intermittently. Follow now the steps from DAILY PROGRAMMES section until the display shows again
process with the 7 days of the week. When the display shows
dia1
If the display shows
It is possible to allocate any of the three temperature levels to all the intervals of any day maintaining the relevant
until an audible signal is heard.
To turn back a controller from 24hr/7days to a single 24hr press
KEYBOARD LOCK

Press the key more than six seconds and the keyboard will be locked. The display will show
working internally. To unlock the keyboard press again the

4. - CLEANING AND MAINTENANCE

Clean and dust with a dry, soft cloth only when the unit is disconnected and cold.
Do not use solvents or abrasive products for cleaning.
This thermal radiator has been manufactured under an assured quality system using environment friendly processes.
Please take the heaters to a clean point once their useful life is finished, in order to recycle their materials in the right way.
5. - TROUBLESHOOTING
- The thermal radiator does not heat. Check the heater or the air inlets are not covered.
- The room does not reach the right
temperature.
- DAY and NIGHT luminous indicators
are lit at the same time.
- The display shows "Err1" or "Err2" Digital models: Contact the after sale service.
- Only daily programmes.
- The keyboard is locked.
P-SE
which means that weekly mode has been set.
key more than two seconds and the display will show the number of the day. Set the correct number, if required,
key and the display will show now the time. Press again the
PRG
then, pressing + key more than three seconds will copy the day 1 program to day 2 and so on.

Digital models: the display shows the time press the
or NIGHT temperatures are right.
Check the selected temperature is in accordance with the desired temperature. Maybe the room needs
more heating power.
Digital models: Continuous mode has been selected. Turn the knob to the "P" position to return to the
Program mode if required.
The controller is in a single 24hr mode (factory default). See WEEKLY PROGRAMMES section to swift to
24hr/7days mode.
If the display shows
than six seconds.
key and at the same time turn the selector to
dia1
key: The display will show
dia7
the weekly program will be stored by pressing
PRG
key more than six seconds. This will restore the factory default settings.
key more than six seconds.
the keyboard is locked. To unlock the keyboard press the
14
P
position maintaining the
key and new values will be stored.
PRG
. Press again key and the display will
dia1
+
key.
and the controller will keep on

key to switch on the heater. Check that the DAY
. Repeat this

key

key more