Mbps Wireless Pc Card Installation; Prepare For Installation - U.S.Robotics R24.0376.00 Guia De Instalacion

22 Mbps Wireless PC Card Installation

Note: For the most updated information, visit: http://www.usr.com/support. You can also
refer to the Companion Reference Guide and to the User Guide on the U.S. Robotics
Installation CD-ROM for more detailed information.

Prepare for Installation

Make sure your computer is turned off. Remove the computer's cover.
Note:
Your product number is 2210. It is very important that you have your serial number
written down before you install the 22 Mbps Wireless PC Card. You can find your serial
number on the back label of the 22 Mbps Wireless PC Card and on the side of the package.
If you ever need to call our Technical Support department, you will need this number to receive
assistance.
Note: Be sure to find out what letter your CD-ROM drive uses before you begin installing
your new product. You will need to know this to properly install your software.
Note: During the Installation procedure, you may be prompted for your Windows
Operating System CD-ROM. Make sure you have that available in case you need it.
Step One: Install your software and drivers*
Note: You will need to install this software on all the laptops you plan to wirelessly network
together.
Insert your U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Note: If the Choose Setup Language window appears, select your preferred language and
click OK.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, and type
D:\setup (or the appropriate letter of your CD-ROM drive) and click OK.
Some files will be copied to your system, and then you will be asked to read the license
agreement. Read the agreement and click Yes.
The Installation CD Graphic User Interface (GUI) will appear on your screen. Click Software.
Click Install Wireless Card Utility and Drivers. Follow the on-screen instructions and wait for
some files to be copied to your hard drive. A window will appear showing you the files that are
being loaded onto your system. If you are prompted to reboot your computer, select Yes, I want
to restart my computer now and click Finish.
*A "Digital Signature Not Found" screen may appear. Click Yes. Windows Me and 2000 will verify
that your network device is properly installed.
1