Installation - Dimplex BOF4056 Manual Del Propietário

Installation

The Optimyst Pro is supplied
in an assembled state and is
designed to be permanently in-
stalled. The unit comes ready for
hardwire installation.
WARNING: Construction and
electrical outlet wiring must
comply with local building
codes and other applicable
regulations to reduce the risk
of fire, electric shock and injury
to persons.
WARNING: To reduce the
risk of fire, do not store or use
gasoline or other flammable
vapors or liquids in the vicinity
of the heater.
!
NOTE: A 15 Amp, 120 Volt cir-
cuit is required. A dedicated circuit
is preferred but not essential in all
cases. A dedicated circuit will be
required if, after installation, the
circuit breaker trips or the fuse
blows on a regular basis when the
heater is operating. Additional ap-
pliances on the same circuit may
exceed the current rating of the
circuit breaker.
WARNING: Failure to install
the fireplace as instructed
below may result in damage
to the equipment and or may
expose the user to the risk of
6
fire, serious injury, illness or
death.
WARNING: Do not attempt to
wire your own new outlets or
circuits. To reduce the risk of
fire, electric shock or injury to
persons, always use a li-
censed electrician.
WARNING: Ensure that the
On/Off switch is set to the Off
position (refer to Operation
section) and that the circuit
on which the fireplace is to be
installed has the power cut off
at the service panel until instal-
lation is complete.
!
NOTE: Please read all instruc-
tions before installing.
1. For rough in framing, the
opening should follow the
recommended dimensions
located in Figure 1.
!
NOTE: Dimensions provided
are minimum clearances and will
vary depending on type of support
framing and finishing options.
! NOTE: It is recommended
that the bottom of the unit not be
mounted higher than 40 in. (1020
mm) from the ground to maintain
an optimized viewing angle of the
flame (Figure 2).
www.dimplex.com