S witch the AUTO / OFF switch
j
casing
into the AUTO position to recharge the rechargeable
5
battery
.
9
Changing the rechargeable battery
Q
note: You will need a crosshead screwdriver for this step.
F irst push the AUTO / OFF switch
j
T ake the decorative attachment
j
light bulb
3
j
P ull the rod with the LED light bulb
j
O pen the battery compartment
casing
. To do so, unscrew both screws using a crosshead
5
screwdriver .
R emove the used rechargeable battery
j
I nsert a new rechargeable battery (NiMH, AA, 1.2 V
j
600 mAh) into the battery compartment
note: Ensure correct polarity. This is indicated in the battery
compartment
j
C lose the battery compartment
screws using a crosshead screwdriver .
W hen you close the case
j
not pinched.
P lace the rod with the LED light bulb
j
again.
j
P lace the decorative attachment
bulb
.
2
.
.
10
5
on the bottom of the solar
11
to the OFF position.
11
off the rod with the LED
1
off the middle rod
3
on the bottom of the solar
10
.
9
.
10
. To do so, screw in both
10
, make sure that the cables are
onto the middle rod
3
back onto the LED light
1
.
6
/
6
GB/MT
41