Maintenance And Care; Emptying The Dirty Water Tank - Rug Doctor FlexClear FCM-1 Manual Del Usuario

Maintenance and Care:

REMOVING UPHOLSTERY TOOL
1
Turn The
Machine Off
Turn the machine off by
pressing the POWER
SWITCH down to the
center "OFF" position.
3
Remove The
Upholstery
Tool
Remove the
UPHOLSTERY TOOL
by squeezing on the
sides of the
connector and
pulling from the
UPHOLSTERY TOOL
PORT.
5
Empty The
Water Tanks
Empty the CLEAN WATER
TANK and DIRTY WATER
TANK as necessary. Rinse,
dry and replace on the
machine as directed in
STORAGE INSTRUCTIONS.
14
F L E X C L E A N® A L L - I N - O N E F L O O R C L E A N E R
2
Unplug
The Machine
Unplug the
POWER CORD
from the outlet
and wrap it
around the
POWER CORD
WRAP.
4
Attach Nozzle
Attach SOFT SURFACE OR HARD
SURFACE NOZZLE by:
3
1. Align the nozzle tabs
2
with the slots in the
base, just in front of the
BRUSH ROLL.
2. Rotate NOZZLE toward
machine.
1
3. Latch the NOZZLE by
pressing down on the top of the
nozzle until you hear a "click."
6
You Are Ready To
Deep Clean Or Store
The Machine.
| U s e r M a n u a l
Maintenance and Care:

EMPTYING THE DIRTY WATER TANK

IMPORTANT
:
Empty the DIRTY WATER TANK before the dirty water reaches the "FULL LINE."
1
Turn The
Machine Off
Press the POWER
SWITCH to the "OFF"
position.
3
Remove The
Dirty Water Tank
Remove the DIRTY
WATER TANK by
grasping the TANK
HANDLE and lifting
straight up.
5
Secure The Dirty
Water Tank
Place the DIRTY
WATER TANK back
onto the machine by
setting it straight
down on the base.
r u g d o c t o r . c o m | 1 - 8 0 0 - 7 8 4 - 3 6 2 8
2
Unplug The
Power Cord
Unplug the POWER
CORD from the outlet
and wrap it around the
POWER CORD WRAP.
4
Empty The Dirty Water
Unscrew the DIRTY WATER CAP
counter-clockwise and set aside.
Pour out the dirty water.
Rinse out the DIRTY WATER TANK
thoroughly with warm water.
Replace DIRTY WATER CAP.
NOTE: DO NOT pour into sink or
tub. Dirty water should be poured
into toilet or outside.
6
For A Deeper Clean
To clean the DIRTY WATER TANK more thoroughly:
1. Turn the DIRTY WATER TANK upside down to
locate the FLOAT CAP.
2. Unscrew the FLOAT CAP turning
counterclockwise.
3. Remove the FLOAT ASSEMBLY. Clean inside the
tank with a towel or a cleaning brush.
4. Replace the FLOAT ASSEMBLY. Firmly tighten the
DIRTY WATER CAP by turning clockwise until
tightened.
15