Example Of A Practical Application In Order To Certify An Installation By Using The Tv Explorer - Promax OP-009-PS Manual De Instrucciones

User's Manual OP-009-PS
Each measurement made in each measurement point collects the following data
for the three wavelengths:
REF (Reference):
LEVEL:
ATT (Attenuation):
PASS / FAIL:
After measuring and storing all measurement points of the installation, they can
be download to the PROMAX NetUpdate3 program to be shown on a certification
report.
3.1.2
Example of a practical application in order to certify an
installation by using the TV EXPLORER
Next there is a step by step example to certify a telecommunication installation
of optical fibre by using the TV EXPLORER
To make the required certification it is necessary:
A TV EXPLORER
-
A signal generator of the three wavelengths used in fibre optical installations
-
in order to calibrate and measure (PROLITE-105).
- A pigtail with a FC to SC adapter.
Step 1.- Capturing reference measurements.
1.- Connect the SC pigtail end connector to the PROLITE-105 output connector.
2.- Connect the FC end of the pigtail to the optical input of the TV EXPLORER
HD (see figure below).
3.- Turn on the PROLITE-105 and the TV EXPLORER HD.
4.- In the TV EXPLORER
menu.
09-2012
Measure of power level at the reference signal.
Power level at the current point of measurement.
Difference between reference and level.
Status message depending on the value defined in the
configuration option "Maximum Attenuation".
HD optical module.
HD with the optical module.
HD press the key
HD optical module
[22] to access the UTILITIES
Page 7