Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Instructions for use:
For best results:
Take a warm bath or shower, to open up your pores, and use a loofa sponge or exfoliation cream
in small circles to remove dead skin from the area you wish to remove hair. Doing this before you
use your Zepter Hair Remover will cleanse and make your skin pliable, so removing hair will be
less uncomfortable.
1. Use your Zepter Hair Remover in a location that has a comfortable
temperature to avoid perspiration.
2. Make sure that the areas you wish to remove hair from are clean, dry
and free from moisturizing cream or oil.
3. To use your unit as a cordless device, plug it into an electrical outlet
and let it initially charge for 16 hours. After the initial charge you can
use it until you notice that it is losing power. Then recharge your unit
for 8-16 hours, depending on battery power (fig 1-4).
4. If your unit is not charged, insert the adapter plug into the bottom
of the unit and plug your adapter into an electrical outlet.
4
Using the Epilation Head:
1. Remove the protective cap, by gently
pulling, from your Zepter Hair Remover
(fig 5).
2. Turn your unit to the desired speed, low
is recommended for fine hair and high is
1
recommended for coarse hair (fig 6).
1
3. To minimize discomfort, hold the
skin taut surrounding the area you are
1
1
removing hair from (fig 7).
4. Position your Zepter Hair Remover so
1
that it is vertical against your skin, at a 90°
angle (fig 8).
1
1
1
1
5. Keep the stainless steel tweezers upright;
1
the Zepter Hair Remover logo should be
1
2
2
facing away from you.
6. Gently glide the Zepter Hair Remover in
2
short, quick, brush like or sweeping
2
strokes in the direction of hair growth (fig 9).
2
Note: For you protection, your Zepter Hair
2
Remover may slow down, or stop operating
completely if it is pressed too hard against
2
2
2
the skin.
2
3
2
7. If it has been an extended amount
3
of time since you have removed hair from
you bikini line and underarms, trim the
3
hair with scissors or a trimmer. Make sure
3
to hold the skin taut with one hand while
3
3
removing hair.
8. The Zepter Hair Remover is only
intended to remove individual hairs from
3
3
3
the upper lip (fig 10), chin and cheek area.
3
4
When removing hair from these
3
4
sensitive skin areas please hold the
surrounding area taut. Do not use this unit
4
by the eyebrows, forehead or hairline.
4
4
4
4
4
4
4
4
5
8
5
8
5
8
5
8
5
8
5
8
5
8
5
8
5
8
5
8
5
8
6
9
6
9
6
9
6
9
6
9
6
9
6
9
6
9
6
9
6
9
6
9
7
10
7
10
7
10
7
10
7
10
7
7
10
10
On the Back of the Knee
7
10
7
10
7
10
Straighten your leg so that the skin is held taut
7
10
and hold the Zepter Hair Remover so it is vertical
against your skin, at a 90° angle.
EN
5
Publicidad
Tabla de contenido
