LAVOR Pro MAJOR Manual De Instrucciones página 21

2) Press the main switch situated on the control pa-
nel to the ( I ) ON ⑩ position -for working on
mains power
or
( II ) ON - for working on battery
IMPORTANT: the machine is battery operated
with either the plug attached to the electrical
mains or the machine operated with the plug di-
sconnected from the electrical mains.
3) Press the BOILER ON button situated on the con-
trol panel to ( I ) ⑪.
6) If the display show H2O , it means that there is
no water in the tank. Fill the tank (see "Filling the
tanks with water and detergent")
> TO SPRAY DETERGENT
To spray and mix the detergent with steam:
- Press button ⑰ on the pistol grip.
.> Machine stop (at end of work)
At the end of the work shift, stop the machine in the
following way:
1) Press boiler switch button to (0) OFF ⑪
2) Press main switch to (0) OFF ⑩.
3) Unplug the machine from the electrical power
supply.
OPERATION
1 Boiler cleaning
2 Visual checks
3 Cleaning the
burner
4 General clea-
ning
MACHINE PART
1 Remove limestone from the boiler
2 Machinery + gun
2 Electrical parts
2 Integrity of the water and steam
hoses and gun
3 Ignition electrodes, Diesel nozzle
4 External cleaning
Boiler steam discharge
Follow the instructions below:
- A few minutes before the end of the work shift,
turn off the boiler by pressing the BOILER START
luminous green push-button, continuing to use
the steam gun until the pressure gauge indicates
a value of 0-1 bar;
see fig. F (Optional)
Follow the instructions below:
- Carefully open the boiler drain cock, situated on
the machine right side and drain all the water
from the boiler into a suitable container;
WARNING: Danger from hot steam.
IMPORTANT: Should it be necessary for any
reason to de-activate the machine quickly, place
the main switch on the control panel to the OFF
position.
• WARNING:
• V15
While the machine is functioning, it
is strictly forbidden to remove safety devices
set by the Manufacturer for the purpose of
protecting the operator against incidents.
- Only skilled and qualified operators must use
the machine.
- Avoid aiming the steam lance towards
personnel or delicate objects such as plastic,
crystal or other materials which may melt or
deteriorate with contact to steam at 180°C.
- Never leave the machine unattended.
- Always remove the power supply from the
PERIODICITY
1 Every year
2 Every week
2 Every mont
3 Every year
4 Every week
21
EN
Authorized After Sales
Service
The user
The user
Authorized After Sales
Service
The user