Customer Responsibilities - Craftsman 536.884780 El Manual Del Propietario

CUSTOMER RESPONSIBILITIES
SERVICE RECORDS
Fill in dates as you complete
regular service
After
First 2
hours
SCHEDULE
iii
Before As Every Every Every Each Before
Each Needed 5 10 25 Season Storage
Use Hours Hours Hours
SERVICE
DATES
m
Check Engine OilLevel _ _
Change Engine Oil j_ j_ p_
Tighten All Screws and Nuts /_ pJ
Lubricate All Pivot Points _ pJ
Lubricate Auger Shaft (See Shear
Bolt Replacement) pJ PJ
Check Auger Clutch Cable
Adjustment (See Cable Adjustment) PJ PJ
Adjust Drive Belt pJ /_
Check Fuel jr_
Drain Fuel
Replace Spark Plug p,# pj
, , ......
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does notcover items
that have been subjected to operator abuse or negli-
gence. To receive full value from the warranty, operator
mustmaintain snow thrower as instructedin this manual.
Some adjustments will need to be made periodicallyto
properly maintain your snow thrower.
All adjustments in the Service and Adjustments section of
this manual should be checked at least once each
season.
AFTER FIRST USE
• Check for any loose or damaged parts.
• Tighten any loose fasteners.
• Check and maintain the auger.
• After each use, remove all snow and slush off the
snow throwerto prevent freezing of augerorcontrols.
• Check controls to make sure they are functioning
properly.
• if any parts are worn or damaged, replace
immediately.
LUBRICATION CHART
shaft.
Coat with a clinging type
grease such as Lu]_riplate or
fiber impregnated grease.
15