General Operation; Start-Up Test And Adjustment; Start; Stop - DST DR-40 T10 Manual Del Usuario

5 OPERATION

5.1 GENERAL OPERATION

The mode switch has two operation modes.
• Manual (MAN
• Automatic (AUTO
available in auto-mode.
*) Option
Attention!
• AUTO-VENT
• AUTO-OFF
Caution!
5.2
1. Inspect and clean the inside of the unit from foreign objects such as rags, tools, particles of metal, and such, that may pose damage to the inside of the unit.
2. If any, ensure that both air balance dampers are open and check that the air paths of the duct work are not obstructed in any way.
3.
4. Check and, if needed, reduce the electrical consumption to the recommended . See
5. If applicable, check that the rating of the electrical supply fuses is correct, see wiring diagram.

5.3 START

1. Switch MAN/AUTO to "MAN" (AUTO-mode can only be used if an humidistat is connected).
2. Switch ON/OFF to "ON" (The unit starts running).
3.

5.4 STOP

1. Switch ON/OFF to .
1. Elapsed time meter
2. Ammeter (only displays the heater
current)
3. MAN/AUTO
4. ON/OFF
5. Humidistat plug
6.
DR-40 T10, T16 EN.03
and see heater current in
13
EN
.
Seibu Giken DST