Publicidad
Idiomas disponibles
Idiomas disponibles
USES
The appliance has been designed to work
both in filtering and sucking mode.
* In the filtering version (fig. 1), the air and fu-
mes conveyed by the appliance are purified by
both a grease filter and an activated charcoal fil-
ter, and then re-circulated into the room through
the side-grids of the chimney.
When the appliance works in this mode, we re-
commend the use of an air deflector (Fig. 1A) to
be placed on the upper part of the pipe, allowing
the air to be re-circulated into the room.
* In the sucking version (fig. 2), fumes are di-
rectly conveyed outside the building, through the
top or rear air out-let. The use of a charcoal filter
and air deflector is not necessary in this case.
INSTALLATION
*Before installing the appliance, make sure that
none of the parts is damaged in any way.
In case of damaged parts, contact your retailer
and do not proceed with installation.
Read all of the following instructions carefully be-
fore installing the appliance:
- Use an air outlet pipe of the shortest possible
length.
- Limit the number of pipe elbows.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in the pipe section
(recommended constant diameter: Ø 150 mm or
equal surface area).
-The manufacturer shall not respond for air ca-
pacity or noise problems due to non- compliance
with above mentioned instructions, and no war-
ranty shall be given.
This product has been designed with the possibi-
lity of directing the air outlet to the rear.
To do this it is necessary to remove the metal co-
ver by unscrewing the two screws (Fig. 3). Then
remove the motor by unscrewing the 4 fixing
screws and position it in the rear hole of the hood.
Finally place the cover previously removed in the
upper hole. (Fig. 4)
By using its drilling template (fig. 5A), drill the ho-
les for the wall bracket installation;
Appliances shall be installed at a minimum di-
stance of 650mm from the cook-top.
Fix the brackets to the wall, by using the screw
anchors and screws supplied with the product;
Hang the body (Fig. 6) to the wall brackets pre-
viously fixed.
Screw the two screws into the wall bracket (fig.
7A) necessary to adhere the product to the wall,
then check that the hood is perfectly flat, if not,
use the screws indicated in fig. 7B, by screwing
the screw to raise the corresponding side or by
unscrewing it if necessary it is necessary to re-
duce the height.
Make the electrical connection using the appro-
priate power cable.
12
Publicidad
