Removing Collected Water; Water Level; Bucket Operation - GE ADHB35 El Manual Del Propietario

Using the Dehumidifier
Always make sure the water bucket is locked into place on the dehumidifier.

Removing Collected Water

There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed, the unit will
shut off. Empty and replace the bucket.
IMPORTANT: Do not use the hose if using the bucket to
collect water. When the hose is connected, water will flow
through it onto the floor instead of into the bucket.
Bucket
NOTES:
• Do not remove the bucket while the dehumidifier is
operating or if it has just stopped operating. This might
cause some water to drip from the drain pan.
• The bucket must be in place and securely seated for the
dehumidifier to operate.

Water Level

is full, or when the bucket is removed or not replaced in the
proper position.

Bucket Operation

If removed the Dehumidifier will not work properly.
49-5000443 Rev. 1
Handle
Use a hose. Water can be automatically emptied into a floor
drain by attaching a garden water hose (not included).
1. Remove the bucket from the front of the unit.
2. Open the drain cover on the side of the unit.
Drain hose
3. Thread a garden hose (not supplied) onto the nozzle, cut to
length, and lead it to the floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely seated for
the dehumidifier to operate.
dehumidifier will not run if the bucket is not in the proper
position.
7