Peavey CEL-2A Manual De Instrucciones página 7

R R E E A A R R P P A A N N E E L L
( ( 1 1 8 8 ) ) A A C C M M a a i i n n s s I I n n p p u u t t
Connect the appropriate line cord to this connector to provide power to the unit. Damage to the equipment
may result if improper line voltage is used. Operate only with the specified AC input voltage applied.
( ( 1 1 9 9 ‚ ‚ 2 2 0 0 ‚ ‚ 2 2 6 6 ‚ ‚ 2 2 7 7 ) ) B B a a l l a a n n c c e e d d O O u u t t p p u u t t s s
XLR and 1/4" TRS‚ servo-balanced‚ line level outputs. Pin 2 (tip) is the positive phase‚ pin 3 (ring) is the
negative phase. If unbalanced outputs are used the negative phase must be grounded. The XLR and 1/4"
TRS jacks are wired directly in parallel.
( ( 2 2 1 1 ‚ ‚ 2 2 8 8 ) ) I I n n p p u u t t / / O O u u t t p p u u t t
This unbalanced 1/4" TRS jack has both input and output signals. It is configured so that a standard (not
cross wired) stereo shielded cable can be used to plug into the TRS insert of a mixer. (The tip is input‚ ring
is output‚ which match the insert jack wiring of all current Peavey mixers.)
( ( 2 2 2 2 ‚ ‚ 2 2 3 3 ‚ ‚ 2 2 9 9 ‚ ‚ 3 3 0 0 ) ) B B a a l l a a n n c c e e d d I I n n p p u u t t s s
XLR and 1/4" TRS balanced inputs for line level inputs. Pin 2 (tip) is the positive phase‚ pin 3 (ring) is the
negative phase. If unbalanced inputs are used the negative phase must be grounded. The XLR and 1/4"
jacks are wired directly in parallel.
( ( 2 2 4 4 ‚ ‚ 2 2 5 5 ) ) D D e e t t e e c c t t o o r r S S i i d d e e - - c c h h a a i i n n I I n n s s e e r r t t
A 1/4" stereo (TRS) jack which allows an external device to be inserted into the detector's signal path or
an alternate signal can be brought in to be used as a key. The tip has the send signal and the ring is the
return input. A switch in the jack normally connects the return (ring) to the send (tip) until a plug is
inserted. To use as a ducker‚ apply the controlling signal to the ring connection and adjust the compressor
controls to set the amount and threshold.
7