Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FIRE SAFETY STANDARD
Maintenance
Any unit not in safe operating condition
shall be removed from service.
Precautions.
Repairs to the electrical system of battery-
powered units shall be performed only after
the battery has been disconnected.
Operating Temperature. Where tempera-
ture of any part of the unit is found to be in
excess of its normal operating temperature
and creates a hazardous condition, the unit
shall be removed from service and shall not
be returned to service until the cause for
such overheating has been eliminated.
Fire Prevention. The unit shall be kept in a
clean condition and reasonably free of lint,
excess oil, and grease. Noncombustible
agents are preferred for cleaning the unit.
Flammable liquids [those having flash
points at or above 100°F (37,8°C)] are not
allowed. Precautions regarding toxicity,
ventilation, and fire hazard shall be appro-
priate for the agent or solvent used.
Nameplate Visibility: The unit type designa-
tions as shown on the nameplate and the
type markers shall not be covered over with
paint so that their identification information
is obscured.
The unit shall not be used in classified ar-
eas.
Changing and Charging Storage
Batteries
This section shall apply to batteries used in
electric units. The two types of batteries
commonly used are lead and nickel-iron.
They contain corrosive chemical solutions,
either acid or alkali, and, therefore , present
a chemical hazard. While being charged,
they give off hydrogen and oxygen, which,
in certain concentrates, are explosive.
Battery-charging installations shall be locat-
ed in areas designated for that purpose;
such areas shall be kept free of extraneous
combustible materials. Facilities shall be
provided for the following:
A Flushing spilled electrolyte;
B Fire protection;
C Protecting charging apparatus from
damage by trucks; and
D Adequate ventilation for dispersal of
fumes from gasing batteries.
Where on-board chargers are used, charg-
ing shall be accomplished at locations des-
ignated for that purpose, taking into
account the electrical requirements of the
charger and facilities for fire protection.
Exception: Flushing faclilties shall not be
required if charging is accomplished with-
out removing the battery from the vehicle.
Where handling acid concentrates greater
than 50 percent acid (above 1.400 specific
gravity), an eye-wash fountain shall be pro-
vided.
A conveyor, overhead hoist, or equivalent
material handling equipment shall be pro-
vided for handling batteries.
Chain hoists shall be equipped with load-
cabin containers. Where a hand hoist is
used, uncovered battries shall be covered
with a sheet of plywood or other noncon-
ducting material to prevent the hand chain
from shorting on cell connectors or termi-
nals. A properly insulated spreader bar
shall be used with any overhead hoist.
Reinstalled or new batteries shall meet or
exceed the battery type marked on the unit.
Reinstalled batteries shall be positioned
properly and secured in the unit.
A carboy tilter or siphon shall be provided
where acid in carboys is used. When dilut-
ing concentrated sulfuric acid to make up
electrolyte, the acid ALWAYS shall be add-
ed to the water - not the reverse. Battery
maintenance personnel shall wear protec-
tive clothing such as eye protection, long
sleeves, and gloves.
Exception: Removal and replacement of
batteries shall not require the use of protec-
tive clothing.
Trained and authorized personnel shall
change or charge batteries.
Electrical installations shall be in accor-
dance with NFPA 70, National Electrical
Code, and any local ordinances.
Units shall be positoned properly and
brakes shall be applied before attempting to
change or charge batteries.
Where charging batteries, the vent caps
shall be kept in place to avoid electrolyte
spray. Care shall be taken to ensure that
vent caps are functioning. The battery (or
compartment cover(s) shall be open to dis-
sipate heat and gas.
Smoking shall be prohibited in the charging
area.
Precautions shall be taken to prevent open
flames, sparks, or electric arcs in battery-
charging areas.
Tools and other metallic objects shall be
kept away from the tops of uncovered bat-
teries.
Please read and comply with
these instructions prior to the
initial operation of your appliance. Retain
these operating instructions for future refer-
ence or for subsequent possessors.
Contents
Safety instructions
- Before using the machine for the first
time, read and observe these operating
instructions and the accompanying bro-
chure: Safety information for sweepers
and vacuum sweepers, 5.956-250.
- The operator must use the appliance
properly. He must consider the local
conditions and must pay attention to
third parties, in particular children, when
working with the appliance.
- The appliance must not be operated by
children, young persons or persons who
have not been instructed accordingly.
- Wear proper safety gloves while remov-
ing glass, metal or other sharp-edged
materials from the dirt container.
Warning
Risk of being squeezed or hurt at the belts,
side-brushes, containers, pushing handle.
General notes
Your sales outlet should be informed about
any transit damage noted when unpacking
the product.
Please read the operating instructions
for your machine before using it, and
pay particular attention to the following
safety instructions.
- Warning and information plates on the
machine provide important directions
for safe operation.
- Apart from the notes contained herein
the general safety provisions and rules
for the prevention of accidents must be
observed.
Battery-operated machines
Note
Warranty claims will be entertained only if
you use batteries and chargers recom-
mended by Windsor.
- Always follow the instructions of the bat-
tery manufacturer and the charger man-
ufacturer. Please follow the statutory
requirements for handling and dispos-
ing batteries.
5
6
6
6
6
7
7
8
8
9
9
9
English
5
Publicidad
Capítulos
Tabla de contenido
