Uponor Smatrix Remote Access Module R-56 SMS Manual De Instalación Y Funcionamiento página 9

Normal Usage - Short description
To know the status of your installation you just have to send your
password to your receiver ("PASS" by default) and then it replies with
the following status message:
PASS
TEMP:
INT:20
EXT:15
ALARM1:0
ALARM2:0
OUTPUT=0
You can also receive this message periodically if the HEARTBEAT
parameter is activated.
This message is also sent when an alarm occurs.
Activate/deactivate ECO in the system using the
remote access module R-56
The ECO mode in the Uponor Smatrix Base/Wave/Wave PLUS
controller can be activated/deactivated using the output setting to
reduce or increase the temperature in a remote controlled house in
3 simple steps.
1. Send your password to the receiver.
2. Modify the OUTPUT setting as shown below.
3. Forward message to your receiver.
U P O N O R S M AT R I X R E M O T E A C C E S S M O D U L E R - 5 6 S M S
Your current password
INT - house temperature
EXT - external temperature
ALARM1 - status
ALARM2 - status
OUTPUT - the output status that
controls the ECO setting in the
system
UK
7