User Guide - Evomove Nomi Highchair Guía De Usuario

User Guide

IMPORTANT! READ AND OBSERVE
THE INSTRUCTIONS CAREFULLY AND
KEEP FOR FUTURE REFERENCE.
Congratulations on your purchase of your new
Nomi chair. Using Nomi, you are ready to give
your child a safe and secure start to life at the
table. Start by reading the user guide carefully.
Nomi can be supplied with Nomi Baby, cush-
ions, restraint, harness and tray.
Assembly of highchair
Start by mounting the legs as instructed in the
user guide (fig 1, p. 29). Use the allen keys
and mount on a level surface. Allen keys are
found and stored under the footrest. Proceed
by mounting the back-, seat- and footrest as
instructed in the user guide (fig 1, p. 29). Impor-
tant! Always use the TufLok® coated screws
(TufLok® provides a firmer grip and the screw
do not need to be tightened so often) supplied
with Nomi – the screws are hard to mount and
you have to use both allen keys when mounting
the legs. Keep counter with one allen key and
tighten with the other. See the assemble video
on www.evomove.com.
Adjusting the seat- and footrest
Adjust seat- and footrest, by loosen and tighten
the handles. Start by adjusting the seat height.
The seat height is correct when the child is
seated in the chair with its arms close to the body
and its elbows on level with the tabletop (fig 2A,
p. 30). The seat depth will automatically adjust
to the child. The footrest is at the correct height
when the child's leg has a 90° angle with the feet
flat on the footplate (fig 2B, p. 30). Always adjust
the seat- and footrest to the child's height. Adjust
continuously as the child grows.
Mounting the restraint
The restraint should be used only when the seat
in top position. The restraint is mounted and
removed without using tools. Start by mounting
the restraint below the seat in the groove. Then
tilt the restraint up and click it (audibly) into the
3
backrest (fig 3+4, p. 30). Make sure the restraint
is clicked into place and can not be pulled off.
Cleaning and care
The chair can be cleaned with a damp clot and
a mild detergent. Brightly coloured foods (like
curry and ketchup) can discolour the plastic.
Black lines can be removed with white eraser.
Please note that the chair's colours may fade
over time if the chair is exposed to direct sunlight.
Made with care
Plastic parts are FIRA tested and made of poly-
propylene and wood meets the FSC standards.
Textiles comply with Oeko-Tex Standard 100.
Safety approval
Nomi High Chair complies with all requirements
of the European safety standard EN 14988- 1/2:
2006 + A1: 2012 and EN 12520: 2010.
GARANTI OG REKLAMATION
All wooden, plastic and metal parts are subject
to a two-year guarantee. The guarantee cov-
ers defective material and design faults. The
guarantee does not cover defects due to normal
wear, improper use of the product, changes
to the product after purchase and the use of
accessories which have not been approved
and marketed by Evomove A/S. The guarantee
does not apply in the event of non-compliance
with the instructions for installation, use and
maintenance included with the product.