Craftsman professional 152.229010 Manual De Instrucciones página 15

Figure 5-3 Figure 5-5
D
E
G
3, Piace adjustabie handie (D) onto quHi advancement
shaft (E), See Figure 5-3,
Figure 5-4
F
NOTE: Make certain that the spindie taper (G) and the
tapered hob in the chuck (H) are clean and free of
grease, iacquer, or rust preventive coatings, See
Figure 5-5 Househoid oven cieaner can effectiveiy
remove any substance from the spindie and chuck,
Carefuliy follow the manufacturer's safety rubs con-
cerning its use,
Figure 5-6
K
4,
Tighten two set screws (F) on the adjustable han-
dle, one shown on Figure 5-4, Once both are tight-
ened, back off both setscrews one rotation, This
will allow the handle to rotate freely,
5, Open the chuck jaws completely, hold the top collar
(I) and turn the chuck barrel (J) counter-clockwise,
Make sure the jaws are completely recessed inside
the chuck, See figure 5-6,
6, Seat the chuck onto the drill press spindle as far as
it wiii go, Carefully drive the chuck onto the spindle
by placing a wooden block (K) under the chuck (L)
and tap the block up with a hammer (M),
IMPORTANT: DO NOT tap the chuck directly with a
metal hammer,
15