Mason & Deck ME2MOGO Manual Del Propietário página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USE & OPERATION (CONTINUED)
FILLING WITH WATER (CONTINUED)
Manual Water Tank Refill:
Using a portable container or a garden hose, you can refill
the water tank manually by pouring water into the water
tank through the water inlet hole located at the top of the
air cooler.
Check the water level indicator to know when the water
tank is full. Do not fill water above the "Max." water level
mark to avoid water droplets collecting on the louvers.
WARNING: Always ensure the water in the water tank is above the minimum (Min.) water level mark for
both Continuous & Manual Water Refill. Running the unit in Cool mode with inadequate water may cause
pump failure.
Note: The water capacity refers to the total volume of water that can be contained within the air cooler
water tank and water distribution system. The water capacity in the tank at the "Max." indicator level may
be lower than the actual water capacity of the air cooler.
WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and Honeycomb
media.
LOW WATER PUMP CUT-OFF*
In Cooling Mode, when water in the tank is below the minimum indicator level, the air cooler water
pump will automatically turn off. This helps to protect the water pump from running without water in the
tank. When the water pump is turned off, the air coolers stops evaporative cooling.
To reactivate the water pump and restart the unit in Cooling Mode, first switch OFF the unit and unplug
from the power outlet. Fill the water tank with fresh water above the minimum level mark. Plug in and
switch the unit ON again.
*Applicable for models with Low Water Pump Cut-off only.
12
Water Inlet Hole
Water Fill
Door
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Me1mogo

Tabla de contenido