Palmgren 29503A Manual De Funcionamiento Y Lista De Piezas página 3

Palmgren Operating Manual & Parts List
OPERATION
Refer to Figure 2.
• Mount vise to work surface in desired
location by securing all three mounting
flanges located on base (Ref. No. 2). Use
three 7 / " diameter bolts, 2 inches longer
16
than the bench top thickness, flat wash-
ers and nuts (not supplied). Do not weld
vise to any metal object. Make sure the
bench top to which the vise is mounted
is properly secured.
• Secure vise in position by hand tight-
ening the lock handles (Ref. No. 17). Do
not use a pipe extension or cheater
bar. This may cause handles to bend
and overstress locking bolt threads.
• To adjust the angle of the jaws, loosen
bolts (Ref. No. 24), pull out lock pin
knob (Ref. No. 22) and rotate the jaws.
The lock pin knob can also be used to
quickly set the jaws at eight positions,
45° apart. Set the jaws at the required
angle and retighten the bolts.
• Open jaws of vise and place workpiece
between jaws in desired position.
Secure workpiece between jaws by
rotating leadscrew handle (Ref. No. 13).
Be sure workpiece is held securely in
vise. Never use hammer, pipe extension
or cheater bar on leadscrew handle of
vise.
MAINTENANCE
Particles of metal or wood can damage
machined surfaces, causing difficult or
inaccurate operation.
• The vise is shipped with a protective
coating. This coating should be
removed before operation. Use pene-
trating oil to remove protective coating.
• Keep machined surfaces and all mov-
ing parts clean and free of dirt, chips
and foreign materials.
• Keep machined surfaces lubricated
with medium weight machine oil.
3
29503A