OPERATING GUIDE
STEP 1
To Insert and Remove the Battery
• The Spray Deterrent requires 4 replaceable AAA
batteries (not included).
• The Battery Door is located on the top of the
Motion Detector Unit. Slide the Battery Door open.
• Insert the 4 AAA batteries as shown.
• Replace the Battery Door by positioning the top
edge, and snap the bottom of the Battery Door
back into place.
Battery Life
Average battery life is 2-3 months, depending on
how often the Motion Detector Unit activates. To
conserve battery life, turn to the OFF ( O ) position
while the Spray Deterrent is not in use.
STEP 2
Prepare the Spray Deterrent
• Turn the Motion Detector Unit OFF ( O ).
• Place Motion Detector Unit on top of the Spray Can by pressing down fi rmly. The unit will clamp
onto the Spray Can. Then slide the Locking Ring down to secure the unit into position.
• Adjust the Motion Sensor setting and the Spray Direction Switch to fi t the desired deterrent area.
• To remove the Motion Detector Unit from the Spray Can, turn the unit OFF ( O ), then lift up the
Locking Ring and remove the unit.
www.petsafe.net
7