GHP Group Thermoheat RMC-KFA75TL Manual De Instrucciones página 6

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
2. ASSEMBLY
Tools required for Assembly :
ⅰ) Medium Phillips Screwdriver.
ⅱ) 3/4 inch Socket or Adjustable Wrench
For RMC-KFA75TL Model only
(Assembly time for this product is 5 minutes)
Tools Required
• Medium Phillips Screwdriver.
1) Lift front guard for arrow direction and make
sure that guard's wedged portion fits into the slit
hole on the upper housing.
2) Align the holes in the upper housing with two
mounting holes on the handle as shown in Figure 6.
3) Secure handle with Screws with provided.
4) Insert cord wrap into the rectangle holes on the supporter
and align the hole on the cord wrap with the mounting
hole on the side cover as shown in Figure 6.
5) Secure cord wrap with Screws with provided.
For RMC-KFA125TL1/210TL1 Models only (Assembly time for this product is 10 minutes)
Tools Required
• 3/4 inch Socket or Adjustable Wrench
1) Align and insert snapfit front leg in to the front section of the bottom leg and wheel support. You will need
to depress the metal buttons when installing. See Figure 7 below.
2) Slide threaded axle through the rear sectioon of the bottom leg and wheel support.
3) Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle. Attach one
cap nut on to each side of the threaded axle and tighten well.
4) Align and insert snapfit front and rear handles to the top support handle. You will need to depress the metal
buttons on each handle when installing. See Figure 7 below.
Button
Hole
Top Handle Support
Snap Fit Front Leg
Bottom Leg And Wheel Support
CAUTION : DO NOT OPERATE heater without support frame assembled to tank.
NOTE : Heater should be inspected before each use, and at least annually by a qualified service person.
Wheel
Cap Nut
Figure 7. Assembling Handles & Wheels
Handle
Supporter
Figure 6. Assembling Handle & Cord Wrap
Snap Fit Front Handle
Snap Fit Rear Handle
5
Screw
Front Guard
Wedged Portion
Slit Hole
Cord Wrap
Side Cover
Screw
Threaded Axle
Bushing