Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEmblING mANTEl
ImPORTANT: more than one person is required to lift
assembled mantel. lift mantel by leg assemblies. lifting
by header or mantel top could damage mantel.
1. Some models require side/corner assembly. For these
models, lay leg front on soft cloth on floor. Position leg
as shown in Figure 1. Align bottom and attach with 1
screws through pocket holes. Repeat for other side.
2. Each leg assembly will use 3 brackets for stability. Your
bracket hardware kit will contain either 1/2" or 3/4" screws.
Using 1/2" or 3/4" screws, install a bracket in the center of
each leg assembly and one at each end within 1" of but
not over the last pocket hole (see Figure 2).
3. Place header between right and left leg assemblies (see
Figure 3). Make sure header and legs are snug against
each other. The top of the header must be flush with the
top and sides of leg assemblies. Attach header through
predrilled holes with 1
as shown in Figure 3. Attach flat brackets with 1/2" or 3/4"
screws using 1 flat bracket and 4 screws per side (see
Figure 4).
1
/
" Screws
1
4
Leg Side
Figure 1 - assembling Legs
Figure 2 - Installing Brackets
2
⁄
" screws on each leg assembly
1
4
Leg Front
Bracket
1/2" or 3/4"
Screw
Left
Side Leg
Assembly
/
"
1
4
Leg
Assembly
Figure 4 - Installing Header and Brackets
FOR INSTAllATION WITh DImPlEx
ElEcTRIc FIREPlAcE ONly
If installing with a gas fireplace, proceed to attaching
top of mantel, page 3.
1. Locate Dimplex filler components and gather tools required
for assembly.
WARNING: Only use 1
Dimplex kit pieces. Damage to the mantel will result if
other screws are used for this purpose.
2. Place large header portion face down on a soft surface.
3. Using 1
/
1
ends of Dimplex header (see Figure 5, page 3).
4. Using 1
1
/
4
of Dimplex header (see Figure 5, page 3).
cAUTION: When attaching blocks be careful that
they do not spin with drill. This may cause injury.
5. Place mantel face down on soft surface.
6. Place Dimplex kit header into space below mantel header
(see Figure 6). Push the kit header tightly against mantel
header and attach blocks to mantel using 1
provided.
7. Carefully set mantel upright.
www.desatech.com
Figure 3 - Installing Header
/
" screws to assemble
1
4
" screws provided, attach short blocks to both
4
" screws provided, attach long block to top edge
Header
Top of
Mantel
Right
Side Leg
Assembly
1/2" or 3/4" Screws
Flat
Bracket
Header
1
/
" Screws
1
4
/
" screws
1
4
119939-01A
Publicidad
Tabla de contenido
