Ordering Replacement Parts; Disposal And Recycling - EINHELL NWH 2000 Manual De Instrucciones

Anleitung_NWH_2000_SPK7:_
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or ISC GmbH in
compliance with the relevant regulations.
Important: Disconnect the mains lead before
cleaning – danger of electric shock.
Use a damp cloth to clean the casing.
The equipment is fitted with an air intake filter. We
recommend that you check and clean the air
intake filter every month.
Cleaning the air intake filter (Fig. 4 / 5)
1. Carefully pull the air intake cover (1) upwards
using the two notch mounts (A), open the air
intake cover upwards and remove the air intake
filter (B).
2. Clean the air intake filter (B) using a vacuum
cleaner or wash it in warm water (max. 40°C).
3. Then dry the filter in a cool place.
4. Fit the air intake filter back into the equipment and
close the air intake cover again until the notch
mounts audibly click into position.
There are no parts inside the equipment which
require additional maintenance.

10. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

11. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
03.06.2008 10:36 Uhr Seite 11
GB
11