Craftsman 917.28825 Manual Del Operador página 20

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A
ARNING:
TO AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY SER-
VICE OR ADJUSTMENTS:
1.
Depress
clutch/brake
pedal fully and set parking
brake.
2.
Place
gearshift
lever in neutral
position.
3.
Place
attachment
clutch
in "DISENGAGED"
position.
4.
Turn ignition
key to "STOP"
and remove
key.
5.
Make sure the blades
and all moving
parts have completely
stopped.
6.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come
in contact
with plug.
TO REMOVE
MOWER
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Lower attachment
lift lever to its lowest
position.
3. Roll belt off engine pulley (M) and belt
keepers (G).
4. Remove retainer spring (K), slide collar
(L) off and push housing guide (P) out
of bracket.
5. Remove clutch cable spring (Q) from
idler arm (R).
6. Disconnect front link (E) from mower
- remove retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis pin (B) and rear lift link (C)
from rear mower bracket (D) - remove
_
retainer springs and washers.
CAUTION:
After rear lift links are
disconnected,
the attachment
lift lever will
be spring loaded. Have a tight grip on lift
lever when changing position of the lever.
8. Slide mower out from under right side
of tractor.
IMPORTANT:
If an attachment
other than
the mower is to be mounted on the tractor,
remove the front link (E) and rear lift liks
(C) from tractor and hook the clutch spring
(Q) into the cable guide on front edge of
lower dash.
TO INSTALL
MOWER
Be sure tractor is on level surface and
engage parking brake.
1. Lower attachment
lift lever to it's lowest
position.
_, CAUTION:
Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before slid-
ing mower under tractor.
2. Slide mower under tractor until it is
centered under tractor.
3. ATTACH MOWER SIDE SUSPEN-
SION ARMS (A) TO CHASSIS - Posi-
tion hole in arm over pin (B) on outside
of tractor chassis and secure with
retainer spring.
4. Repeat on opposite side of tractor.
20
03042tex

Publicidad

Tabla de contenido
loading

Tabla de contenido